Sunrise Red Oxide Primer
Sunrise Redoxide Primer is a high quality of air drying anti-rust most suitable for metal surfaces as a base coat for air drying enamel.
MAIN USES:
On all interior and exterior steel or metal surfaces to protect them against corrosive weathering conditions.
| COVERING CAPACITY | 11-13m°/ litter per oat (20-25 microns per coat) |
|---|
DRYING TIME
| Surface Dry | 2-3 Hour |
|---|---|
| Hard Dry | 24 hours |
| Recoatability | 16 hours |
| Gloss | Slight Sheen |
| SOLID (VOL%) | 55 ‡ 2 |
| SPECIFIC GRAVITY | 1.30 - 1.50 |
THINNING::
Use best quality white spirit to thin Sunrise Red Oxide Primer, as required for paint brush or spray application.
SURFACE PREPARATION:
Before apply application ensure the metal surface is absolutely free from rust, grease & welding flux, which can be achieved by wire brushing, abrasive or sand papering and finally whipping with solvent soaked rag.
PRECAUTIONS:
After use the sunrise red oxide primer keep paint container air tight and store in a shady & dry place if paint spills on to your body or in your eyes, wash thoroughly with clean or heat water.
CLEANING:
Clean all equipment with mineral turpentine (MTT) immediately after use it.
APPLICATION:
Apply one coat by paint brush. Let it dry for 20-24 hours, wet sand it with abrasive paper No. 320 and then apply the finish.
PRECAUTIONS:
Keep sunrise red oxide primer paint container air tight after use . Keep it away from open flame & heat. Where the painting area is in progress ensure adequate ventilation.
0 Comments